			Sphere Dialog Help
				for 
			Picaso Version 1.0
Sphere Radius:  This is the radius of the sphere in logical units

X Location: This is the X axis location of the sphere in the 
	    3D universe. The X axis runs from right to left of the screen. 
	    Positive X values will place the sphere to the right of the 
	    center of the universe. Negative X values will place the 
	    sphere to the left of the center of the universe.

Y Location: This is the Y axis location of the sphere in the 3D universe. 
	    The Y axis runs from the top to the bottom of the screen. 
	    Positive Y values will place the sphere above the center of 
	    the universe. Negative Y values will place the sphere bellow 
	    the center of the universe.

Z Location: This is the Z axis location of the sphere in the 3D universe. 
	    The Z axis runs from the foreground to the background. Positive
	    Z numbers will place the sphere behind the center of the 
	    universe. Negative Z numbers will place the sphere in front of
	    the center of the universe.

OK Button: Clicking on this button will accept the Sphere location and size,
	   and then it will open up the surface attributes dialog. Also if
	   you press enter at any time the dialog is shown it will be just 
	   like clicking on the OK button.
 
Cancel:	Clicking on this button can cause two things to happen. If this is 
	a new sphere picaso will not create a new sphere. If the sphere is
	being edited it will cancel the changes you have made to the sphere.

Coordinate System:	      Above	
			       +Y  +Z Farther
				|  /
				| /
				|/
		     Left -X----0----X+ Right
			       /|
			      /	|
			     /	|
		    Closer -Z  -Y
			      Below 


